Print Page | Close Window

Connect line to a circle

Printed From: CAD Forum
Category: EN
Forum Name: AutoCAD
Forum Description: Discussion about AutoCAD and AutoCAD LT, viewers, DWG and DWF formats, Design Review, AutoCAD 360, add-ons
URL: https://www.cadforum.cz/forum_en/forum_posts.asp?TID=12244
Printed Date: 20.Apr.2026 at 10:40


Topic: Connect line to a circle
Posted By: HarunT
Subject: Connect line to a circle
Date Posted: 02.Mar.2017 at 16:53
uploads/710612/images_1.pdf" rel="nofollow - uploads/710612/images_1.pdf

Hi there, 
how can i connect this line to any point on the circle? this is what it looks like when i zoom in. 
 hope you can help. 


-------------
HT


Replies:
Posted By: Vladimir Michl
Date Posted: 02.Mar.2017 at 16:59
If you use OSNAP, your geometry should be precise - despite it may be displayed disconnected in extreme zoom levels.
 
Make sure your geometry is not too far from the world origin (0,0,0).


-------------
Vladimir Michl (moderator)
ARKANCE - https://arkance.world" rel="nofollow - https://arkance.world - Autodesk Platinum Partner

Posted By: John Connor
Date Posted: 02.Mar.2017 at 17:08
If the line is not connected to a quadrant or tangent to the circle then to connect it to any point on the circle try drawing a temporary line that intersects the circle then use the INTERSECTION osnap to make the connection.


-------------
"Humans have a strength that cannot be measured. This is John Connor. If you are reading this, you are the resistance."

<<AutoCAD 2015>>

Posted By: Kent Cooper
Date Posted: 02.Mar.2017 at 18:58
If you used some Osnap mode to put it on the Circle, or Trim or Extend, and if this is Zoomed significantly in since then, it's just a matter of display resolution.  REGEN and it will probably meet visually [it really does meet geometrically already].  It's a function of the way curves are segmented in display only.  To at least lessen the effect, go into VIEWRES and give it a higher Circle Zoom Percentage.


Print Page | Close Window