3D printing
Printed From: CAD Forum
Category: EN
Forum Name: AutoCAD
Forum Description: Discussion about AutoCAD and AutoCAD LT, viewers, DWG and DXF formats, Design Review, AutoCAD web, Drive, add-ons
URL: https://www.cadforum.cz/forum_en/forum_posts.asp?TID=12722
Printed Date: 12.Jun.2026 at 14:40
Topic: 3D printing
Posted By: Glynndale702
Subject: 3D printing
Date Posted: 01.May.2018 at 07:29
|
I am trying to create a project for 3 D printing this is my
first time and I having allot trouble doing it can any body help me figure this
out I would really appreciate it what I am trying to do is make a new car radio
dash bezel the measurements for it is in picture attached picture 1 I tried to
created a stl file so it could be printed so
I don’t know if I did this right can anybody take a look at this and tell what’s
wrong or help me design it better I went to send it to get printed but then it
asked me scale it is this the right measurements to get it printed
Size 1.00 x20.00x13.64mm (0.04 x 0.79 x 0.54 in)
I would appreciate any help thanks guys 
|
Replies:
Posted By: John Connor
Date Posted: 01.May.2018 at 11:18
|
A quarter of an inch thick? Seems rather thick for a bezel. You don't give the radius for the two upper corners nor do you provide a radius for the filleted edge. So you created a drawing in AutoCAD and exported it as a .stl file. Is that correct? ------------- "Humans have a strength that cannot be measured. This is John Connor. If you are reading this, you are the resistance." <<AutoCAD 2015>> |