Polylines
Printed From: CAD Forum
Category: EN
Forum Name: CAD - general
Forum Description: General discussion about CAD, formats, standards, management, licensing, networking, harware, other CAD applications
URL: https://www.cadforum.cz/forum_en/forum_posts.asp?TID=180
Printed Date: 06.May.2026 at 18:30
Topic: Polylines
Posted By: gclifton
Subject: Polylines
Date Posted: 16.Oct.2007 at 02:08
I seem to remember from years ago that there was a command that brought up a dialog box where you could set the way that lines and polylines joined. Sometimes I've seen where polylines have join that the resulting joint was not always clean and smooth. I think that this included the "fuzzy" joining where you could set an acceptable gap length between the lines.
Any help would be appreciated.
Thanks.
|
Replies:
Posted By: Vladimir Michl
Date Posted: 16.Oct.2007 at 08:43
There is a fuzzy setting in the PEDIT Multiple Join command (or there is an old PLJOIN tool).
-------------
Vladimir Michl (moderator)
ARKANCE - https://arkance.world" rel="nofollow - https://arkance.world - Autodesk Platinum Partner
|
|