Print Page | Close Window

Line Protruding

Printed From: CAD Forum
Category: EN
Forum Name: AutoCAD
Forum Description: Discussion about AutoCAD and AutoCAD LT, viewers, DWG and DWF formats, Design Review, AutoCAD 360, add-ons
URL: https://www.cadforum.cz/forum_en/forum_posts.asp?TID=2259
Printed Date: 01.Jun.2026 at 00:58


Topic: Line Protruding
Posted By: cure4glass
Subject: Line Protruding
Date Posted: 27.Jul.2009 at 18:03

I have drawings with assigned plot styles for certain lines, set up in Plot Style Table Editor. Here’s my issue. The plotted line weights for these lines are 1.2 mm .I had the line end style set as Square. The lines were protruding past the object or line they were intersecting with. I changed the line end Style to Butt hoping that it would correct the problem, but no luck.Any suggestions?


Replies:
Posted By: Draftman
Date Posted: 28.Jul.2009 at 16:32
If all lines are the same weight you should be ok. If you have a thicker line runing into a thiner one, this happens.
 
Also, click on the line that's acting up & see if the griping point is going past the line you're intersecting too. I'll try to quickly lay lines down & my o-snap will grab something i didn't want it to if you have objects close together.
 
Zoom in, cause it's hard to notice on large drawings sometimes. It also helps me to highlight everything in the area just to see grips of things I may not have caught while not selected.
 
I'm sure you'll kick yourself when you find out what it is.


Print Page | Close Window