Print Page | Close Window

1 was filtered out - Multileader

Printed From: CAD Forum
Category: EN
Forum Name: AutoCAD
Forum Description: Discussion about AutoCAD and AutoCAD LT, viewers, DWG and DWF formats, Design Review, AutoCAD 360, add-ons
URL: https://www.cadforum.cz/forum_en/forum_posts.asp?TID=411
Printed Date: 31.May.2026 at 22:20


Topic: 1 was filtered out - Multileader
Posted By: Philip-Acumis
Subject: 1 was filtered out - Multileader
Date Posted: 21.Jan.2008 at 16:29
Autocad 2008
I am trying to use Collect Multileaders on a couple of multileaders I have created using the toolbar but I keep getting the message "1 was filtered out".
The Collect Multileader command works if I use Multileaders from the Tools Palette.
Has anyone seem this before and am I doing something wrong?
Philip


Replies:
Posted By: Arben.Allaraj
Date Posted: 22.Jan.2008 at 14:06
 
 Try this way:
 
 Type  "Filter" or FI in Command prompt and then modify it.


-------------
Ing Arben.Allaraj
http://cad-drafting-corner.blogspot.com

Posted By: Philip-Acumis
Date Posted: 23.Jan.2008 at 17:52
After a little bit of looking on the net I got the impression that Multileader collect only works with leaders that use blocks so I tryed it myself and it works as long as I use block and not Mtext.
Is this the way it supposed to work?
Philip.


Print Page | Close Window