Creating Patio
Printed From: CAD Forum
Category: EN
Forum Name: AutoCAD
Forum Description: Discussion about AutoCAD and AutoCAD LT, viewers, DWG and DWF formats, Design Review, AutoCAD 360, add-ons
URL: https://www.cadforum.cz/forum_en/forum_posts.asp?TID=5901
Printed Date: 16.May.2026 at 23:35
Topic: Creating Patio
Posted By: thrice910
Subject: Creating Patio
Date Posted: 17.May.2011 at 05:51
|
Hello all, I cannot figure out how to create a solid surface on top of the retaining walls and also how to grade the transitions for the high to low points of the retaining wall. This would be so much easier for me in Solid Works >< Any help would be appreciated.  Doug |
Replies:
Posted By: John Connor
Date Posted: 17.May.2011 at 11:45
|
It appears that all of your walls are surfaces and not solids. I suspect that you extruded a series of lines. Is that correct? Did you know that a solid can be created using the Press/Pull command? ------------- "Humans have a strength that cannot be measured. This is John Connor. If you are reading this, you are the resistance." <<AutoCAD 2015>> |
Posted By: John Connor
Date Posted: 17.May.2011 at 15:12
|
Looks like someone posted an answer to your question over at CADTutor.
------------- "Humans have a strength that cannot be measured. This is John Connor. If you are reading this, you are the resistance." <<AutoCAD 2015>> |