Block problem
Printed From: CAD Forum
Category: EN
Forum Name: AutoCAD
Forum Description: Discussion about AutoCAD and AutoCAD LT, viewers, DWG and DXF formats, Design Review, AutoCAD web, Drive, add-ons
URL: https://www.cadforum.cz/forum_en/forum_posts.asp?TID=6058
Printed Date: 04.Sep.2026 at 11:14
Topic: Block problem
Posted By: heckman
Subject: Block problem
Date Posted: 11.Jun.2011 at 15:30
So I have created multiple blocks in my drawing and saved them. When I insert them into my drawing it is inserting the block, although it is in multiple lines not as one entity. Any suggestions!? 
|
Replies:
Posted By: John Connor
Date Posted: 11.Jun.2011 at 22:52
|
Did you save each block individually or were all the "blocks" (as you call them) saved as one?
------------- "Humans have a strength that cannot be measured. This is John Connor. If you are reading this, you are the resistance." <<AutoCAD 2015>> |
Posted By: heckman
Date Posted: 11.Jun.2011 at 23:02
| They were saved individually in another drawing and inserted into my new drawing. |
Posted By: Imad Habash
Date Posted: 12.Jun.2011 at 07:35
well... when the insert dialogue appear , check out the EXPLODE small box down there..
i hope it's help.
Regards,
|