Some CAD help needed
Printed From: CAD Forum
Category: EN
Forum Name: CAD - general
Forum Description: General discussion about CAD, formats, standards, management, licensing, networking, harware, other CAD applications
URL: https://www.cadforum.cz/forum_en/forum_posts.asp?TID=7797
Printed Date: 02.Jul.2026 at 22:21
Topic: Some CAD help needed
Posted By: cfsound
Subject: Some CAD help needed
Date Posted: 14.May.2012 at 23:09
hello there everyone,
Im new here and new to CAD ive recently been putting some thought into making my own version of a parabolic dish for nature recording (sure you've had this come up before) what i want is a parabolic dish in cad to send to a vacuum forming company to be made to my personal specifications, however im not quite sure how to do it. and i thought where best to go than a CAD forum, hope im not above my station here, and hope i haven't posted in the wrong section, any help on this matter would be greatly appreciated!
Thankyou!
|
Replies:
Posted By: John Connor
Date Posted: 15.May.2012 at 00:11
I would suggest that it be done as a 3D model and then have any required 2D views (top, front, side, etc.) extracted.
What program were you considering using?
Are you a student?
-------------
"Humans have a strength that cannot be measured. This is John Connor. If you are reading this, you are the resistance."
<<AutoCAD 2015>>
|
|