Wrap Text File to 3D Path Inventor 2013
Printed From: CAD Forum
Category: EN
Forum Name: Inventor
Forum Description: Discussion about Autodesk Inventor
URL: https://www.cadforum.cz/forum_en/forum_posts.asp?TID=8189
Printed Date: 20.Apr.2026 at 02:04
Topic: Wrap Text File to 3D Path Inventor 2013
Posted By: cjjatpuresilica
Subject: Wrap Text File to 3D Path Inventor 2013
Date Posted: 02.Aug.2012 at 15:46
I have recently posted about applying text to a spherical surface and
following the advice of John Connor and in turn earlier advice on the
subject by JD Mather, I have been successful in part. However if my text
box exceeds the width of my spherical part the Extrude-Cut fails.
Is there a means of getting my 2D Text Sketch to wrap to a 3D curve and if so is this likely to overcome the above problem?
In other words how do I get a 2D Text Box to wrap around a Spherical
part without the above limitation of the width of the Text Box having to
be less than the width of the part as viewed during the sketch creation
window.
I realise that this is easy when executed on a cylinder but Inventor doesn't take quite so kindly to spheres.
Any ideas please?
|
Replies:
Posted By: John Connor
Date Posted: 02.Aug.2012 at 18:08
Why don't you post your question in the AutoDesk Discussion Group for Inventor if you haven't already done so? Since you did not get a satisfactory answer the first time you posted here what makes you think you'll get one on the second go around?
Or...do it in AutoCAD then bring the results into Inventor.
-------------
"Humans have a strength that cannot be measured. This is John Connor. If you are reading this, you are the resistance."
<<AutoCAD 2015>>
|
Posted By: rappelzdzd
Date Posted: 03.Aug.2012 at 04:07
do it in AutoCAD then bring the results into Inventor.hope you can succeed,good luck!
-------------
I heart which I could not help him
|
|