Print Page | Close Window

STEP conversion

Printed From: CAD Forum
Category: EN
Forum Name: CAD - general
Forum Description: General discussion about CAD, formats, standards, management, licensing, networking, harware, other CAD applications
URL: https://www.cadforum.cz/forum_en/forum_posts.asp?TID=823
Printed Date: 04.Jul.2026 at 17:36


Topic: STEP conversion
Posted By: emonje
Subject: STEP conversion
Date Posted: 13.Jun.2008 at 04:51

Hello,

We need to convert a bungh of CATIA V5 part files into STEP. I was thinking of using stand-alone converters like CADFix or Transmagic & doing a mass cakculation check afterwards. I don't have much experience in this. Is a mass check enough to protect against dangling edges/unsewn surfaces etc.? What kind of problems can I expect to run into. Can anyone please give me some suggestions?

Thanks.


Print Page | Close Window