1.   Which of the following AutoCAD features allows you to pick up points only along the horizontal and vertical quadrant lines from a given starting point?

 A. LINE

B. Snap

C. Ortho

D. 3D Object Snap

My Answer: B   

 3.   Which of the following statements about Grid is correct?

 A. Grid is only a visual reference; it has no effect on the selection of points.

B. Grid effects the selection of points.

C. Grid is invisible.

D. Grid and Snap always have the same setting.

My Answer: B   

 8.   When you're inputting coordinates at the on-screen prompt, which one of the following statements is correct?

 A. Relative coordinates are specified by typing coordinates with no prefix.

B. Absolute coordinates are specified by typing the @ prefix.

C. Relative coordinates are specified by typing the # prefix.

D. Absolute coordinates are specified by typing the # prefix.

My Answer: A   

 10.   When drawing a horizontal line that's 15 decimal units long to the right, the correct polar coordinate display should read

 A. 15.0000 < 90,0.0000.

B. 0.0000 < 15,0.0000.

C. 15.0000 < 180,0.0000.

D. 15.0000 < 0,0.0000.

My Answer: C   

 13.   The default paper size and grid line increments for an acad.dwt drawing template is

 A. 8 1/2 inches × 11 inches, and 1.0000 spacing.

B. 12 inches × 9 inches, and 0.5000 spacing.

C. 11 inches × 17 inches, and 1.0000 spacing.

D. 24 inches × 36 inches, and 0.5000 spacing.

My Answer: C   

 14.   After executing the ZOOM command, the following information appears in the command line:

 [All/Center/Dynamic/Extents/Previous/Scale/Window/Object]

If you press <Enter> on your keyboard in response to this prompt, which of the following ZOOM options will be activated?

C. All

D. Extents

My Answer: C   

 16.   Where should you look on the AutoCAD screen to find the application status bar?

 A. On the left edge of screen

B. At the top of the screen

C. At the bottom of the screen

D. On the right edge of the screen

My Answer: D   

 17.   Using Dynamic Input and decimal units, imagine that you've drawn a jagged line that ends at the absolute coordinates (5, 8). To draw a line back to the XY origin using absolute coordinates, you should type _______ at the Specify next point: prompt.

A. −5, −8

B. 0,0

C. #−5,−8

D. #0,0

My Answer: A   

 20.   You can press the <F7> key in AutoCAD to turn on the

 A. Polar Tracking.

B. Ortho Mode.

C. Grid Display.

D. Snap Mode.

My Answer: B