Default configurations
Printed From: CAD Forum
Category: EN
Forum Name: CAD - general
Forum Description: General discussion about CAD, formats, standards, management, licensing, networking, harware, other CAD applications
URL: https://www.cadforum.cz/forum_en/forum_posts.asp?TID=897
Printed Date: 15.Jun.2026 at 05:55
Topic: Default configurations
Posted By: Prophet
Subject: Default configurations
Date Posted: 15.Jul.2008 at 19:12
Hello. I'm a amateur user of AutoCAD and today when I started drawing I realized that when I selected an endpoint it didn't show the drawing's units or angle. And I can not see or toogle between them using the TAB-key. This is really getting on my nervs so if someone know any way to make the default config the current or what I could've changed by mistake so I may correct it I will be most thankful. 
Cheers // Robert |
Replies:
Posted By: Arben.Allaraj
Date Posted: 15.Jul.2008 at 21:48
May be some ways to avoid it. Go to Tools-->options-->Profiles--->unnamed profile. Or check the AutoCAD Workspace!. ------------- Ing Arben.Allaraj http://cad-drafting-corner.blogspot.com |
Prophet wrote:Posted By: AllieEatsSushi
Date Posted: 15.Jul.2008 at 22:32
|
Depending on how old your version of AutoCAD is (I have 2009.) This is what worked for me.
-Right click on Snap
-Click 'Dynamic Input' to change your crosshair reference and data, or change the prompting of information your crosshairs give you.
-Or, click the 'Options' tab at the bottom left corner, and it lists options for your personal preference.
~Hope this helps. ------------- -Allie |
Posted By: Prophet
Date Posted: 16.Jul.2008 at 19:25
|
Thanks, all works as usual now. Much appreciation to you two. Thanks, once again. // Robert |