DraftSight question
Printed From: CAD Forum
Category: EN
Forum Name: CAD - general
Forum Description: General discussion about CAD, formats, standards, management, licensing, networking, harware, other CAD applications
URL: https://www.cadforum.cz/forum_en/forum_posts.asp?TID=9166
Printed Date: 09.Jun.2026 at 22:23
Topic: DraftSight question
Posted By: itzamaija02
Subject: DraftSight question
Date Posted: 22.Apr.2013 at 00:21
I have loaded a copy of DraftSight. When I try to select multipal enties with the pick box it un-selects the previous one when I select the new one. I know this must be a setting that needs to be changed, but can not find it.
Any advice would be appreciated.
|
Replies:
Posted By: John Connor
Date Posted: 22.Apr.2013 at 11:55
I'd try either PICKFIRST or PICKADD or whatever the AutoCAD equivalent command is in DraftSight.
I think these are the equivalent commands in DraftSight:
ENBLENTSELPRESEL
SETENTSELADD
Set each to a value of "1".
-------------
"Humans have a strength that cannot be measured. This is John Connor. If you are reading this, you are the resistance."
<<AutoCAD 2015>>
|
|