Print Page | Close Window

New to the forum..

Printed From: CAD Forum
Category: EN
Forum Name: AutoCAD
Forum Description: Discussion about AutoCAD and AutoCAD LT, viewers, DWG and DWF formats, Design Review, AutoCAD 360, add-ons
URL: https://www.cadforum.cz/forum_en/forum_posts.asp?TID=9275
Printed Date: 19.May.2026 at 08:37


Topic: New to the forum..
Posted By: wilsonreef
Subject: New to the forum..
Date Posted: 08.Jun.2013 at 04:43
I am new to this forum, and to AutoCad.  I have played around with it for some time, but I'm, by far, not good at it yet.  I was wondering how do you pick a surface to work on?  Meaning, for example, I have a box and want to put a slot in the top of it 1/4" x 1/4" dp.  Then I want to go to the end (either one) and put a slot in the end of the box with the same dimensions.  After I make the slot in the top, how do I go to the end and pick that surface to put the slot in the end? 
Hope I haven't made this too terribly confusing.  I will have other questions I'm sure.  Thanks for anyone's help.
 
Carl


Replies:
Posted By: John Connor
Date Posted: 08.Jun.2013 at 12:37
Can we assume you are working in 3D?  If so, have you looked at using the Dynamic UCS option?  And are you familiar with the PressPull command?


-------------
"Humans have a strength that cannot be measured. This is John Connor. If you are reading this, you are the resistance."

<<AutoCAD 2015>>


Print Page | Close Window