Print Page | Close Window

2D line to move on 3D point

Printed From: CAD Forum
Category: EN
Forum Name: AutoCAD
Forum Description: Discussion about AutoCAD and AutoCAD LT, viewers, DWG and DWF formats, Design Review, AutoCAD 360, add-ons
URL: https://www.cadforum.cz/forum_en/forum_posts.asp?TID=9369
Printed Date: 16.May.2026 at 14:33


Topic: 2D line to move on 3D point
Posted By: MilanNS
Subject: 2D line to move on 3D point
Date Posted: 04.Jul.2013 at 13:49
How to move LINE to 3D point, or point in block? XY are same,Line is on Z=0 and point is above.


Replies:
Posted By: John Connor
Date Posted: 04.Jul.2013 at 18:06
Use a filter?


-------------
"Humans have a strength that cannot be measured. This is John Connor. If you are reading this, you are the resistance."

<<AutoCAD 2015>>

Posted By: MilanNS
Date Posted: 05.Jul.2013 at 08:31
filter to select and?

Posted By: John Connor
Date Posted: 05.Jul.2013 at 14:16
To place the point relative to an X/Y coordinate.


-------------
"Humans have a strength that cannot be measured. This is John Connor. If you are reading this, you are the resistance."

<<AutoCAD 2015>>

Posted By: Kent Cooper
Date Posted: 08.Jul.2013 at 21:13

Maybe I don't understand what you're asking, but it sounds to me as though you should be able to select the Line, pick on any of its grips, hit Enter/space to get into the Move command, and then either object-snap to the 3D location if you can, or else use the .XY option and snap to the appropriate point on the Line, then give it a Z value or snap to anything in the Block that is at the desired elevation -- that should allow you to snap to some location where it's not going to snap to the Line again.

Posted By: MilanNS
Date Posted: 09.Jul.2013 at 12:41
I have a lot of lines on elevation zero (Z=0) and I need  to make a 3D drawing from it. And all lines have a points on edge. I can easy set points to 3D positions, but lines are problems. i can do that manually, line to 3D point but its to slow and i think maybe someone on this forum have a AutoCAD Lisp for it.  


Print Page | Close Window