Print Page | Close Window

Trouble opening drawings

Printed From: CAD Forum
Category: EN
Forum Name: CAD - general
Forum Description: General discussion about CAD, formats, standards, management, licensing, networking, harware, other CAD applications
URL: https://www.cadforum.cz/forum_en/forum_posts.asp?TID=9527
Printed Date: 29.Sep.2026 at 12:04


Topic: Trouble opening drawings
Posted By: Dont Blink
Subject: Trouble opening drawings
Date Posted: 13.Aug.2013 at 16:31
"Fatal Error" unable to load modeler DLLs is the message that I receive when I attempt to open an existing drawing. I can open the cad program and start drawing a new one, but if I try to open an existing one from either my desk top icon, or while in a new drawing that is the code that I get.
Any thoughts?
 
I was just updating these drawings yesterday with out any trouble, left work and came in this morning to this.
Thank you
 
 


Replies:
Posted By: John Connor
Date Posted: 13.Aug.2013 at 18:04
Refer to this article that comes directly from AutoDesk:

http://usa.autodesk.com/adsk/servlet/ps/dl/item?siteID=123112&id=11775759&linkID=9240617

If this does not solve your problem then come back and tell us.


-------------
"Humans have a strength that cannot be measured. This is John Connor. If you are reading this, you are the resistance."

<<AutoCAD 2015>>

Posted By: Dont Blink
Date Posted: 13.Aug.2013 at 19:03
Thank you for the tip, but it did not seem to work. I followed the instructions as you said, but no luck.
Also all of the icons have changed a bit on each of my cad files that are on my desktop. Red band on the bottom of the icon with a "A" on the top gray backround

Posted By: John Connor
Date Posted: 13.Aug.2013 at 23:12
Did you change the file association designation?  What program were you using previously?


-------------
"Humans have a strength that cannot be measured. This is John Connor. If you are reading this, you are the resistance."

<<AutoCAD 2015>>

Posted By: andrew_neil
Date Posted: 14.Aug.2013 at 11:26
You can also try Microsoft system restore pvoided that you have created a previous restore point.It will rescue your pc to the last known best configuration .
Hope it helps.

Posted By: Dont Blink
Date Posted: 20.Aug.2013 at 19:24
Just to follow up, I reinstalled the software and everything seems fine. Not really sure what caused it, but glad to be back.
Thank you for the help!
 
 


Print Page | Close Window