Print Page | Close Window

Subbassembly composer codes and targets , problem

Printed From: CAD Forum
Category: EN
Forum Name: Civil 3D, Map, InfraWorks
Forum Description: Discussion about mapping and GIS applications Map, Civil3D, InfraWorks, MapGuide and Raster Design
URL: https://www.cadforum.cz/forum_en/forum_posts.asp?TID=9630
Printed Date: 14.May.2026 at 10:15


Topic: Subbassembly composer codes and targets , problem
Posted By: Aistis88
Subject: Subbassembly composer codes and targets , problem
Date Posted: 10.Sep.2013 at 08:05

I create assemblys using "Autodesk subassembly composer ". I import them and build a corridor from them.   If i make corridor from one assembly with "pave offset target" and other "target to surface" i have to set those targets in corridor. Problem is  - if that corridor have like for example 10 regions, i have to set same targets for  all regions and its is quite difficult , couse usually i have like 2-3 assemblys with different construction but the same targets and like 20-30 regions , so if my corridor  must target pave offset i have to set that SAME target for the right and for the left side 30x2 = 60 times.

 

Is there any possibility that could remove this misery ?


Print Page | Close Window