HELP:Warning When Run Simulation/Stress Analysis
Printed From: CAD Forum
Category: EN
Forum Name: Inventor
Forum Description: Discussion about Autodesk Inventor
URL: https://www.cadforum.cz/forum_en/forum_posts.asp?TID=9675
Printed Date: 12.May.2026 at 08:22
Topic: HELP:Warning When Run Simulation/Stress Analysis
Posted By: nliegel1974
Subject: HELP:Warning When Run Simulation/Stress Analysis
Date Posted: 26.Sep.2013 at 15:18
|
Using Inventor 2014 and I am trying to run a Simulation for a Stress Analysis and before I hit run, I have a Warning that says that there are no contacts attached to 4 different bodies of my assembly. It will let me run the simulation with the warnings, but have no idea why this is showing up even though I have a number of different bonds associated with each body. Any Ideas? Thanks
|
Replies:
Posted By: raajmath
Date Posted: 26.Sep.2013 at 15:47
share your model lets see which parts are not in contact
|
Posted By: nliegel1974
Date Posted: 26.Sep.2013 at 16:29
|
I am new to Inventor, not sure what all you need to do this? What do I need to do?
|
Posted By: rarevision
Date Posted: 27.Sep.2013 at 02:52
what will happen if you hit 'run'?, will it proceed with the test analysis?
-------------
I am of the universe and you know what its worth.
|
Posted By: nliegel1974
Date Posted: 27.Sep.2013 at 18:03
|
yes, it runs the analysis and shows deflection and stress, just didn't know if there was an issue with my model. Will I be safe to leave it as is then?
|
Posted By: rarevision
Date Posted: 28.Sep.2013 at 01:59
I also did try 'test analysis' and had some pre warnings but proceeded and I leave the computer for 2 days running and finally have the results. I think you should try to do the same
-------------
I am of the universe and you know what its worth.
|
|