![CAD Forum - tips, tricks, discussion and utilities for AutoCAD, Inventor, Revit and other Autodesk products [www.cadforum.cz]](/common/arkance_186.png "CAD Forum - tips, tricks, discussion and utilities for AutoCAD, Inventor, Revit and other Autodesk products [www.cadforum.cz]")
CAD FORUM - TIPS & TRICKS | UTILITIES | DISCUSSION | BLOCKS | SUPPORT | HELP & ADVICE
Over 1.098.000 registered users (EN+CZ).
AutoCAD tips, Inventor tips, Revit tips.
Try the new precise Engineering calculator and the updated Barcode generator.
New AutoCAD 2026 commands and variables.
Discussion forum
?CAD discussions, advices, exchange of experience
CAD discussion forum - ask any CAD-related questions here, share your CAD knowledge on AutoCAD, Inventor, Revit and other Autodesk software with your peers from all over the world. To start a new topic, choose an appropriate forum.
Please abide by the rules of this forum.
This is a peer-to-peer forum. The forum doesn't replace the official direct technical support provided by ARKANCE for its customers.
How to post questions: register or login, go to the specific forum and click the NEW TOPIC button.
how to import a GERBER file? |
Post Reply 
|
| Author | |
Rx-Roberto 
Newbie 
Joined: 3 hours 21 minutes ago Location: Italy Using: Autocad, Solidworks, Freecad Status: Offline Points: 2 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: how to import a GERBER file?Posted: 3 hours 7 minutes ago at 21:51 |
|
Hi all, I'm new in this forum
 I need to import a GERBER file (a PCB drawing) into a CAD (I normally use Freecad ad home and Solidworks at work, but I could use Autocad too). I'd like to import it as a 2D sketch to be extruded later (eg.: 1mm., just to say) I tried different file formats but very often I obtained just splines, without the related tracks, vias and filled areas. I need to import a full design of PCBs, with the original drawing perfectly reproduced. I tried with GERBER, PDF and DXF formats (as output of Kicad) but I was never able to obtain good results. Maybe I'm not following the correct procedure Has anyone already tried to do this? thanks Regards Roberto |
|
 |
|
Topic Options|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
This page was generated in 0,054 seconds.
CADforum
Tips and tricks, support, utilities, help, discussions on AutoCAD, LT, Inventor, Revit, Map, Civil 3D, 3ds Max, Fusion, Forma, Vault, PowerMill and other Autodesk software (community support by ARKANCE). See About CADforum.
Copyright © 2025 | Advertise with us | Online privacy
