Discussion forum

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   Hey everyone,
I wanted to create a Worm Shaft with an increasing Diameter. So 40mm in the beginning and 55mm in the end of the shaft. 

I would like to use the Worm Gear Feature in an Assembly for that matter. Is there any way to achieve this with that Feature? 
Must I draw the Worm Shaft on my own? If so, do you have good resources for this? :/

Cheers
Teecross !

Edited by Teecross - 07.Sep.2018 at 14:59

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
Teecross Members Profile Send Private Message Find Members Posts Add to Buddy List Newbie Joined: 03.Sep.2018 Location: Germany Using: Inventor2016 Status: Offline Points: 12	Topic: Worm Shaft Diameter Posted: 07.Sep.2018 at 14:51
	Hey everyone, I wanted to create a Worm Shaft with an increasing Diameter. So 40mm in the beginning and 55mm in the end of the shaft. I would like to use the Worm Gear Feature in an Assembly for that matter. Is there any way to achieve this with that Feature? Must I draw the Worm Shaft on my own? If so, do you have good resources for this? :/ Cheers Teecross ! Edited by Teecross - 07.Sep.2018 at 14:59

Discussion forum

?CAD discussions, advices, exchange of experience

Worm Shaft Diameter

?
CAD discussions, advices, exchange of experience