![CAD Forum - tips, tricks, discussion and utilities for AutoCAD, Inventor, Revit and other Autodesk products [www.cadforum.cz]](/common/arkance_186.png "CAD Forum - tips, tricks, discussion and utilities for AutoCAD, Inventor, Revit and other Autodesk products [www.cadforum.cz]")
CAD FORUM - TIPS & TRICKS | UTILITIES | DISCUSSION | BLOCKS | SUPPORT | HELP & ADVICE
Over 1.104.000 registered users (EN+CZ).
AutoCAD tips, Inventor tips, Revit tips, Civil tips, Fusion tips.
Try the new precise Engineering calculator.
New AutoCAD 2026 commands and sys.variables and env.variables,.
Discussion forum
?CAD discussions, advices, exchange of experience
CAD discussion forum - ask any CAD-related questions here, share your CAD knowledge on AutoCAD, Inventor, Revit and other Autodesk software with your peers from all over the world. To start a new topic, choose an appropriate forum.
Please abide by the rules of this forum.
This is a peer-to-peer forum. The forum doesn't replace the official direct technical support provided by ARKANCE for its customers.
How to post questions: register or login, go to the specific forum and click the NEW TOPIC button.
Dynamic figures |
Post Reply 
|
| Author | |
Jan Eversdijk 
Newbie 
Joined: 26.Nov.2024 Location: Netherlands Using: Inventor 2023 Status: Offline Points: 2 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: Dynamic figuresPosted: 26.Nov.2024 at 21:58 |
|
Is it possible to add other figures, like the one below, with their own button in the dynamic sketch block. Like a square or rectangle and that you then only have to enter length, width and radius.  |
|
 |
|
|
julecave
Groupie 
Joined: 17.Jul.2022 Location: Palestine Using: audocad 2015 Status: Offline Points: 65 |
Post Options
Thanks(0)
Quote Reply
Posted: 08.Feb.2025 at 21:04 |
|
You're too focused on anatomy/contour instead of gesture which is the far more fundamental and important concept to get dynamic poses.
|
|
|
|
Topic Options|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
This page was generated in 0,332 seconds.
CADforum
Tips and tricks, support, utilities, help, discussions on AutoCAD, LT, Inventor, Revit, Map, Civil 3D, 3ds Max, Fusion, Forma, Vault, PowerMill and other Autodesk software (community support by ARKANCE). See About CADforum.
Copyright © 2025 | Advertise with us | Online privacy
