CAD Forum - Database of tips, tricks and utilities for AutoCAD, Inventor and other Autodesk products [www.cadforum.cz]
Czech English Deutsch
Login/Register:
 Visitors: 3476 
RSS tips RSS channel - CAD tips
RSS discussion RSS channel - CAD discussion

Discussion Discussion forum

HelpCAD discussion

CAD Forum - Homepage CAD discussion forum - ask any CAD-related questions here, share your CAD knowledge on AutoCAD, Inventor, Revit and other Autodesk software with your peers from all over the world. To start a new topic, choose an appropriate forum.

Please abide by the rules of this forum.

How to post questions: register or login, go to the specific forum and click the NEW TOPIC button.
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

The information that you provide in this form will make up your forum profile which can be viewed by other forum members. Your email address will only be visible by forum admin and moderators and will be used to send you Forum Notifications. To cancel your account, use the page Opt-out or contact webmaster@cadforum.cz.

PDF printing crops bottom half of text

 Post Reply Post Reply
Author
imabruce View Drop Down
Newbie
Newbie


Joined: 06.Jun.2014
Location: United Kingdom
Using: AutoCAD2011
Status: Offline
Points: 2
Post Options Post Options   Thanks (0) Thanks(0)   Quote imabruce Quote  Post ReplyReply Direct Link To This Post Topic: PDF printing crops bottom half of text
    Posted: 09.Jan.2020 at 22:28
I have had this issue for a long time and not been able to figure out what causes it.

On a variety of drawings I have a number of Paperspace layout tabs.
Each layout tab has the drawing number in the title block in paperspace in the bottom right corner.

On some tabs, when I print them to PDF, the bottom half of the drawing number is cropped or blanked off, however the rest of the title block lines around and below it print fine.
On other tabs it all prints OK.

The properties of the text appear to be the same and the size of the text frame appears the same on "good" and "bad" tabs.
 
On the "bad" layouts, the cut-off printing happens if I use "Microsoft print to PDF" or "Scansoft PDF Create!" plotters, but there is no cut off if I use "DWG to PDF" plotter.

I assume therefore that it must be a combination of two things:
1. something in the different plotter configs that is different between them
2. something is different in the good and bad paperspace layouts, that the different plotters are treating differently
 
Hopefully someone can assist please as it would be good to be able to have anyone plot any layout on any loaded PDF plotter! 
Many thanks!
Back to Top

Related CAD tips:


 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down



This page was generated in 0,047 seconds.