![CAD Forum - tips, tricks, discussion and utilities for AutoCAD, Inventor, Revit and other Autodesk products [www.cadforum.cz]](/common/arkance_186.png "CAD Forum - tips, tricks, discussion and utilities for AutoCAD, Inventor, Revit and other Autodesk products [www.cadforum.cz]")
CAD FORUM - TIPS & TRICKS | UTILITIES | DISCUSSION | BLOCKS | SUPPORT | HELP & ADVICE
Over 1.099.000 registered users (EN+CZ).
AutoCAD tips, Inventor tips, Revit tips, Civil tips, Fusion tips.
Try the new precise Engineering calculator.
New AutoCAD 2026 commands and variables.
Discussion forum
?CAD discussions, advices, exchange of experience
CAD discussion forum - ask any CAD-related questions here, share your CAD knowledge on AutoCAD, Inventor, Revit and other Autodesk software with your peers from all over the world. To start a new topic, choose an appropriate forum.
Please abide by the rules of this forum.
This is a peer-to-peer forum. The forum doesn't replace the official direct technical support provided by ARKANCE for its customers.
How to post questions: register or login, go to the specific forum and click the NEW TOPIC button.
|
Dynamic block - limited stretch
Post Reply 
|
| Author | |
Rathlo 
Newbie 
Joined: 22.Oct.2014 Location: Slovenia Using: Autocad 2013 Status: Offline Points: 3 |
 Topic: Dynamic block - limited stretchPosted: 28.Nov.2014 at 13:18 |
|
Sorry, I wasn't clear enought. The most right box can also be stretched, so setting max value for the linear parameter of middle box would not solve the problem.
|
|
 |
|
|
gql
Newbie
Joined: 15.May.2013 Location: Hong Kong Using: AutoCAD 2012 Status: Offline Points: 1 |
Posted: 03.Nov.2014 at 04:39 |
|
You can specify max. value (50) of linear parameter.
|
|
|
|
|
Rathlo
Newbie
Joined: 22.Oct.2014 Location: Slovenia Using: Autocad 2013 Status: Offline Points: 3 |
Posted: 22.Oct.2014 at 16:39 |
|
uploads/508690/Dynamic_block_stretch_test.dwg
How to stretch the middle box between the left and right ones only and not outside? I can limit the stretch to the left by specifying min value of linear parameter, but how to prevent stretching over the right box? Any help would be appreciated. Regards, Rathlo
|
|
|
|
Topic Options|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
This page was generated in 0,617 seconds.
CADforum
Tips and tricks, support, utilities, help, discussions on AutoCAD, LT, Inventor, Revit, Map, Civil 3D, 3ds Max, Fusion, Forma, Vault, PowerMill and other Autodesk software (community support by ARKANCE). See About CADforum.
Copyright © 2025 | Advertise with us | Online privacy
