CAD Forum - tips, tricks, discussion and utilities for AutoCAD, Inventor, Revit and other Autodesk products [www.cadforum.cz] ARKANCE | CONTACT - CZ | SK | EN | DE
RSS channel - CAD tips RSS tips
RSS discussions

Discussion Discussion forum

?
CAD discussions, advices, exchange of experience

CAD Forum - Homepage CAD discussion forum - ask any CAD-related questions here, share your CAD knowledge on AutoCAD, Inventor, Revit and other Autodesk software with your peers from all over the world. To start a new topic, choose an appropriate forum.

Please abide by the rules of this forum.
This is a peer-to-peer forum. The forum doesn't replace the official direct technical support provided by ARKANCE for its customers.
How to post questions: register or login, go to the specific forum and click the NEW TOPIC button.
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

Topic ClosedCIMF_USECADLICENSE help....

 Post Reply Post Reply Page  <12
Author
pdraper View Drop Down
Newbie
Newbie


Joined: 11.Aug.2011
Location: United States
Using: Inventor2009, Inventor2011, Autocad arch 2007-2010
Status: Offline
Points: 6
Direct Link To This Post Posted: 12.Aug.2011 at 13:29
14 is not the latest, but it's the one requested for use with a Ford project.. Siemens does have a Help forum, I posted there as well.. They had a few similar questions that were closed, not by the poster but rather by Siemens which was not the root of my cause nor was it the answer to the question that was asked.. Need less to say, which is the reason I am choosing to go else where.. 
Better Lucky Than Good!!
Back to Top
John Connor View Drop Down
Senior Member
Senior Member


Joined: 01.Feb.2011
Location: United States
Using: AutoCAD 2018
Status: Offline
Points: 7175
Direct Link To This Post Posted: 12.Aug.2011 at 01:53
Does Siemens have a Factory Cad Help forum?

Until you mentioned it in your post I never heard of the program.

Is Factory Cad 14 the latest version?
"Humans have a strength that cannot be measured. This is John Connor. If you are reading this, you are the resistance."

<<AutoCAD 2015>>

Back to Top
pdraper View Drop Down
Newbie
Newbie


Joined: 11.Aug.2011
Location: United States
Using: Inventor2009, Inventor2011, Autocad arch 2007-2010
Status: Offline
Points: 6
Direct Link To This Post Posted: 11.Aug.2011 at 22:52
I am getting this error message when launching FactoryCAD from Autocad 2009: CIMFCMDUI17.arx cannot find a procedure that it needs. ; error : ARXLoad failed. CIMFCAD ; error : no function definition: CIMF_USECADLICENSE
 
This is on a 32 bit windows XP machine, I have searched every where for a resolution to this, to no avail.. Factory Cad 14. I have the License.dat file in the Siemens folder and the FactoryConfig.xml is pointing to it. I have uninstalled and reinstalled several times, but this is still beating me.. HELP!! Any feedback would be greatly appreciated..
Better Lucky Than Good!!
Back to Top

Related CAD tips:


 Post Reply Post Reply Page  <12
  Share Topic   

Forum Jump Forum Permissions View Drop Down



This page was generated in 0,229 seconds.