![CAD Forum - tips, tricks, discussion and utilities for AutoCAD, Inventor, Revit and other Autodesk products [www.cadforum.cz]](/common/arkance_186.png "CAD Forum - tips, tricks, discussion and utilities for AutoCAD, Inventor, Revit and other Autodesk products [www.cadforum.cz]")
CAD FORUM - TIPS & TRICKS | UTILITIES | DISCUSSION | BLOCKS | SUPPORT | HELP & ADVICE
Over 1.099.000 registered users (EN+CZ).
AutoCAD tips, Inventor tips, Revit tips, Civil tips, Fusion tips.
Try the new precise Engineering calculator.
New AutoCAD 2026 commands and variables.
Discussion forum
?CAD discussions, advices, exchange of experience
CAD discussion forum - ask any CAD-related questions here, share your CAD knowledge on AutoCAD, Inventor, Revit and other Autodesk software with your peers from all over the world. To start a new topic, choose an appropriate forum.
Please abide by the rules of this forum.
This is a peer-to-peer forum. The forum doesn't replace the official direct technical support provided by ARKANCE for its customers.
How to post questions: register or login, go to the specific forum and click the NEW TOPIC button.
|
changing base angle
Post Reply 
|
| Author | |
paynarc 
Newbie 
Joined: 23.Nov.2008 Status: Offline Points: 3 |
 Topic: changing base anglePosted: 23.Nov.2008 at 03:10 |
|
I cannot change the base angle to north to zero degrees as a Surveyor or compass would have. I have read the HELP notes but it doesn't work.
Stewart |
|
 |
|
|
Kackac
Groupie 
Joined: 03.Oct.2008 Location: Czech Republic Status: Offline Points: 62 |
Posted: 23.Nov.2008 at 18:12 |
|
UNITS and there in the dialogue press button DIRECTION (I'm not sure, I have czech version only), and there set the NORTH... it doesn't work?
Edited by Kackac - 23.Nov.2008 at 18:13 |
|
|
I'm sorry for my bad English. Kackac
|
|
|
|
Topic Options|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
This page was generated in 0,078 seconds.
CADforum
Tips and tricks, support, utilities, help, discussions on AutoCAD, LT, Inventor, Revit, Map, Civil 3D, 3ds Max, Fusion, Forma, Vault, PowerMill and other Autodesk software (community support by ARKANCE). See About CADforum.
Copyright © 2025 | Advertise with us | Online privacy
