CAD Forum - tips, tricks, discussion and utilities for AutoCAD, Inventor, Revit and other Autodesk products [www.cadforum.cz] ARKANCE | CONTACT - CZ | SK | EN | DE
Over 1.096.000 registered users (EN+CZ). AutoCAD tips, Inventor tips, Revit tips. Try the new precise Engineering calculator and the updated Barcode generator. New AutoCAD 2026 commands and variables.
RSS channel - CAD tips RSS tips
RSS discussions

Discussion Discussion forum

?
CAD discussions, advices, exchange of experience

CAD Forum - Homepage CAD discussion forum - ask any CAD-related questions here, share your CAD knowledge on AutoCAD, Inventor, Revit and other Autodesk software with your peers from all over the world. To start a new topic, choose an appropriate forum.

Please abide by the rules of this forum.
This is a peer-to-peer forum. The forum doesn't replace the official direct technical support provided by ARKANCE for its customers.
How to post questions: register or login, go to the specific forum and click the NEW TOPIC button.
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

Topic Closedlines
 Post Reply Post Reply
Author
  Topic Search Topic Search  Topic Options Topic Options
dawnt238 View Drop Down
Newbie
Newbie


Joined: 10.Aug.2007
Status: Offline
Points: 2 		Direct Link To This Post Topic: lines
    Posted: 10.Aug.2007 at 18:25
when im in polar or ortho my lines only goes horizontal. how do i change it to go vertical and diagonal. help please
dnt
Back to Top
Vladimir Michl View Drop Down
Moderator Group
Moderator Group

Arkance Systems CZ

Joined: 26.Jul.2007
Location: Czech Republic
Using: Autodesk software
Status: Offline
Points: 2120 		Direct Link To This Post Posted: 10.Aug.2007 at 18:38
It may be influenced by current SNAP (press F9). Try also to right click on the POLAR button and set the polar angles for Polar snap.
Vladimir Michl (moderator)
ARKANCE - https://arkance.world - Autodesk Platinum Partner
Back to Top
dawnt238 View Drop Down
Newbie
Newbie


Joined: 10.Aug.2007
Status: Offline
Points: 2 		Direct Link To This Post Posted: 10.Aug.2007 at 22:36

thanks, but i tried that already. that was not it.
dnt
Back to Top

Related CAD tips:


 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down



This page was generated in 0,096 seconds.
CADforum
CADforum
Tips and tricks, support, utilities, help, discussions on AutoCAD, LT, Inventor, Revit, Map, Civil 3D, 3ds Max, Fusion, Forma, Vault, PowerMill and other Autodesk software (community support by ARKANCE). See About CADforum.
Copyright © 2025 | Advertise with us | Online privacy
ARKANCE - Autodesk Platinum Partner & Training Center & Services Partner
CONTACT:
webmaster.cz@arkance.world | tel. +420 910 970 111
FB LN TW YT TW Blog RSS
.
TOPlist