CAD Forum - tips, tricks, discussion and utilities for AutoCAD, Inventor, Revit and other Autodesk products [www.cadforum.cz] ARKANCE | CONTACT - CZ | SK | EN | DE
Over 1.094.000 registered users (EN+CZ). AutoCAD tips, Inventor tips, Revit tips. Try the new precise Engineering calculator. New AutoCAD 2026 commands and variables.
RSS channel - CAD tips RSS tips
RSS discussions

Discussion Discussion forum

?
CAD discussions, advices, exchange of experience

CAD Forum - Homepage CAD discussion forum - ask any CAD-related questions here, share your CAD knowledge on AutoCAD, Inventor, Revit and other Autodesk software with your peers from all over the world. To start a new topic, choose an appropriate forum.

Please abide by the rules of this forum.
This is a peer-to-peer forum. The forum doesn't replace the official direct technical support provided by ARKANCE for its customers.
How to post questions: register or login, go to the specific forum and click the NEW TOPIC button.
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

Topic Closedminserted

 Post Reply Post Reply
Author
recustodio View Drop Down
Newbie
Newbie


Joined: 05.Jan.2016
Location: Philippines
Using: AutoCad LT 2015
Status: Offline
Points: 2
Direct Link To This Post Topic: minserted
    Posted: 04.Jul.2016 at 03:41
how to explode minserted file..
recustodio
Back to Top
John Connor View Drop Down
Senior Member
Senior Member


Joined: 01.Feb.2011
Location: United States
Using: AutoCAD 2018
Status: Offline
Points: 7175
Direct Link To This Post Posted: 04.Jul.2016 at 12:06
Try searching for a custom lisp routine.  I think there are one or two available that will do the job.  One of them should be named BLKBUSTEXPLODE MINSERTS.lsp.

I bet you didn't even notice this little gem right under your nose...

http://www.cadforum.cz/cadforum_en/download.asp?fileID=915


Edited by John Connor - 04.Jul.2016 at 12:43
"Humans have a strength that cannot be measured. This is John Connor. If you are reading this, you are the resistance."

<<AutoCAD 2015>>

Back to Top

Related CAD tips:


 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down



This page was generated in 0,117 seconds.