CAD Forum - tips, tricks, discussion and utilities for AutoCAD, Inventor, Revit and other Autodesk products [www.cadforum.cz] ARKANCE | CONTACT - CZ | SK | EN | DE
Over 1.099.000 registered users (EN+CZ). AutoCAD tips, Inventor tips, Revit tips, Civil tips, Fusion tips. Try the new precise Engineering calculator. New AutoCAD 2026 commands and variables.
RSS channel - CAD tips RSS tips
RSS discussions

Discussion Discussion forum

?
CAD discussions, advices, exchange of experience

CAD Forum - Homepage CAD discussion forum - ask any CAD-related questions here, share your CAD knowledge on AutoCAD, Inventor, Revit and other Autodesk software with your peers from all over the world. To start a new topic, choose an appropriate forum.

Please abide by the rules of this forum.
This is a peer-to-peer forum. The forum doesn't replace the official direct technical support provided by ARKANCE for its customers.
How to post questions: register or login, go to the specific forum and click the NEW TOPIC button.
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

Topic ClosedBlock Attribute Move with Lookup
 Post Reply Post Reply
Author
  Topic Search Topic Search  Topic Options Topic Options
Hobblenobble View Drop Down
Newbie
Newbie


Joined: 07.Jan.2016
Location: United Kingdom
Using: 2012 LT
Status: Offline
Points: 7 		Direct Link To This Post Topic: Block Attribute Move with Lookup
    Posted: 07.Jan.2016 at 14:21
Apolgies as a newbie if not posted in the correct discussion.
 
I am pulling out what hair I have left !!!!!
 
I want to generate a dynamic block with an attribute. The attribute in the block depending on the visiblity state (Up/down), should be above or below a line. The distance the attribute needs to move is 8mm. i have tried and dont think I am far off the answer Confused
 
I can create the block and atrribute. I have inserted a linear parameter. A look up table based on the two visible states. It is the move aspect that i think i am stuck on. Any help would be more than appreciated.
 
Kind regards,
 
Hobblenobble
Back to Top

Related CAD tips:


 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down



This page was generated in 0,156 seconds.
CADforum
CADforum
Tips and tricks, support, utilities, help, discussions on AutoCAD, LT, Inventor, Revit, Map, Civil 3D, 3ds Max, Fusion, Forma, Vault, PowerMill and other Autodesk software (community support by ARKANCE). See About CADforum.
Copyright © 2025 | Advertise with us | Online privacy
ARKANCE - Autodesk Platinum Partner & Training Center & Services Partner
CONTACT:
webmaster.cz@arkance.world | tel. +420 910 970 111
FB LN TW YT TW Blog RSS
.
TOPlist