CAD Forum - tips, tricks, discussion and utilities for AutoCAD, Inventor, Revit and other Autodesk products [www.cadforum.cz] ARKANCE | CONTACT - CZ | SK | EN | DE
RSS channel - CAD tips RSS tips
RSS discussions

Discussion Discussion forum

?
CAD discussions, advices, exchange of experience

CAD Forum - Homepage CAD discussion forum - ask any CAD-related questions here, share your CAD knowledge on AutoCAD, Inventor, Revit and other Autodesk software with your peers from all over the world. To start a new topic, choose an appropriate forum.

Please abide by the rules of this forum.
This is a peer-to-peer forum. The forum doesn't replace the official direct technical support provided by ARKANCE for its customers.
How to post questions: register or login, go to the specific forum and click the NEW TOPIC button.
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

Topic ClosedArrayed object will not extrude

 Post Reply Post Reply
Author
Blueoctober712 View Drop Down
Newbie
Newbie


Joined: 20.Jun.2014
Location: United States
Using: AutoCAD2014
Status: Offline
Points: 18
Direct Link To This Post Topic: Arrayed object will not extrude
    Posted: 10.Jul.2014 at 01:06
Please help!!! I created a gear that I need to extude to 1 inch. After I created the object and did all the trimming it will not join as one object using the join command or become a region. It will join together as a block. But the block will not extrude with the extrude command, thicken command etc. I attached a DWG copy. Thank you so much in advance


Regards,
Shan
Back to Top
Blueoctober712 View Drop Down
Newbie
Newbie


Joined: 20.Jun.2014
Location: United States
Using: AutoCAD2014
Status: Offline
Points: 18
Direct Link To This Post Posted: 10.Jul.2014 at 02:14
ok well I used presspull command to get the extrusion. So it looks like a solid object. However it is not and I need to cut out a smaller circumference from the middle for were the axle will slide through. Thanks again
Regards,
Shan
Back to Top

Related CAD tips:


 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down



This page was generated in 0,365 seconds.