CAD Forum - tips, tricks, discussion and utilities for AutoCAD, Inventor, Revit and other Autodesk products [www.cadforum.cz] ARKANCE | CONTACT - CZ | SK | EN | DE
Over 1.096.000 registered users (EN+CZ). AutoCAD tips, Inventor tips, Revit tips. Try the new precise Engineering calculator and the updated Barcode generator. New AutoCAD 2026 commands and variables.
RSS channel - CAD tips RSS tips
RSS discussions

Discussion Discussion forum

?
CAD discussions, advices, exchange of experience

CAD Forum - Homepage CAD discussion forum - ask any CAD-related questions here, share your CAD knowledge on AutoCAD, Inventor, Revit and other Autodesk software with your peers from all over the world. To start a new topic, choose an appropriate forum.

Please abide by the rules of this forum.
This is a peer-to-peer forum. The forum doesn't replace the official direct technical support provided by ARKANCE for its customers.
How to post questions: register or login, go to the specific forum and click the NEW TOPIC button.
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

Topic ClosedCreating Patio
 Post Reply Post Reply
Author
  Topic Search Topic Search  Topic Options Topic Options
thrice910 View Drop Down
Newbie
Newbie


Joined: 17.May.2011
Location: United States
Using: Autocad 2007
Status: Offline
Points: 1 		Direct Link To This Post Topic: Creating Patio
    Posted: 17.May.2011 at 05:51
Hello all,

I cannot figure out how to create a solid surface on top of  the retaining walls and also how to grade the transitions for the high to low points of the retaining wall. This would be so much easier for me in Solid Works ><  Any help would be appreciated.



Doug
Back to Top
John Connor View Drop Down
Senior Member
Senior Member


Joined: 01.Feb.2011
Location: United States
Using: AutoCAD 2018
Status: Offline
Points: 7175 		Direct Link To This Post Posted: 17.May.2011 at 11:45
It appears that all of your walls are surfaces and not solids.  I suspect that you extruded a series of lines.  Is that correct?

Did you know that a solid can be created using the Press/Pull command?


Edited by John Connor - 17.May.2011 at 12:39
"Humans have a strength that cannot be measured. This is John Connor. If you are reading this, you are the resistance."

<<AutoCAD 2015>>
Back to Top
John Connor View Drop Down
Senior Member
Senior Member


Joined: 01.Feb.2011
Location: United States
Using: AutoCAD 2018
Status: Offline
Points: 7175 		Direct Link To This Post Posted: 17.May.2011 at 15:12
Looks like someone posted an answer to your question over at CADTutor.
"Humans have a strength that cannot be measured. This is John Connor. If you are reading this, you are the resistance."

<<AutoCAD 2015>>
Back to Top

Related CAD tips:


 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down



This page was generated in 0,064 seconds.
CADforum
CADforum
Tips and tricks, support, utilities, help, discussions on AutoCAD, LT, Inventor, Revit, Map, Civil 3D, 3ds Max, Fusion, Forma, Vault, PowerMill and other Autodesk software (community support by ARKANCE). See About CADforum.
Copyright © 2025 | Advertise with us | Online privacy
ARKANCE - Autodesk Platinum Partner & Training Center & Services Partner
CONTACT:
webmaster.cz@arkance.world | tel. +420 910 970 111
FB LN TW YT TW Blog RSS
.
TOPlist